BLE 5.2-compatible LTE Cat 4 GNSS tracker with multiple interfaces.

Mini tracker GNSS LTE Cat 4G/3G/2G.

It is used for configuration, firmware update and debug.

The Queclink RS232 Camera is a 300K-pixel camera that features infrared lenses for night vision, captures snapshots per shot, and connects directly to Queclink GV-Series devices via the RS232 serial port. Communication baud rate: 115,200 bps.

Dual-lens LTE Cat 4 DashCam for telematics.

The CAN100 STD decodes information from the vehicle's digital bus (CANBus and J1708) for vehicle monitoring.

The iButton is a Dallas-style key used for driver identification and vehicle ignition control.

The Queclink 5-in-1 Wireless Charger Kit allows for wireless charging of five compatible GL501MG products at the same time.

The Queclink Wireless Charging Kit allows for wireless charging of power supplies.

The Queclink UFS300 is an easy-to-install, environmentally friendly ultrasonic fuel sensor.

The UFS300 diagnostic tool displays fuel data via the LED display.

The Queclink DR102 is an RFID card reader kit that supports multiple MIFARE transponders and has a built-in buzzer.

Protective cabinet with water-resistant magnetic base.

The Queclink GV Series Temperature Sensor Kit can measure and monitor temperature. The AC100 interface can support up to four temperature sensors simultaneously.

The DS18B20 1-Wire digital temperature sensor is used to detect temperature changes within fleet management. It has an eight-meter cable suitable for various installation requirements.

The Queclink AC100 is an RS232 to 1-Wire conversion accessory with a 1-meter cable.

The Queclink AS100 is an active speaker with a 2-meter long cable.

The Queclink CBP is a vehicle battery power adapter compatible with GL300 series products.

It's used to disable the vehicle's starter motor. The relay contains an internal protection diode to prevent reverse voltage or spikes.

Without summary.

Used for configuration, firmware upgrades, and debugging. Includes: DB9 RS232 data cable; 12V US DC jack power supply; GV75 UART PWR conversion interface cable

Used for configuration, firmware upgrades, and debugging. Includes: 12V US DC-jack power supply GV600 series USB to TTL configuration cable

It is used for configuration, firmware update and debug.

It is used for configuration, firmware update and debug.